Workspace Upgrade • Cable Management
How to Hide Desk Wires (Without Losing Your Mind)
Start with a 10-Minute Audit
Before you buy anything, list what actually needs power: laptop, monitor(s), dock, speakers, lamp, phone, tablet, and accessories. Unplug what you don’t use daily and coil the rest. Less gear = fewer cables to hide.
Put Power Where It Belongs
- Mount a power strip under the desk: use screws or 3M-style brackets so bulky plugs stay off the floor.
- Choose a strip with space for bricks: offset outlets prevent “one plug blocking three.”
- Route one single mains cable down to the wall—everything else lives under the desktop.
Use a Cable Tray (Your MVP)
A metal mesh or slim under-desk tray holds the power strip, dock, and extra cable slack. Place it toward the back edge so wires exit near the monitor arm, not the front of your desk.
Guide, Don’t Fight, Your Cables
- Adhesive clips along the underside create clean, predictable paths.
- Velcro ties beat zip ties—reusable, kinder to cables, easier to tweak later.
- Desk grommets (or a clamp-on grommet) take cables straight down, not over the edge.
- Raceways on the wall or the back of a cabinet hide vertical runs to the outlet.
Tame the Desktop
- Wireless keyboard + mouse remove two obvious cords.
- Shorter cables (0.5–1 m) for laptop-to-dock/monitor reduce loops and tangles.
- Right-angle adapters keep plugs low-profile behind monitors or docks.
Dock Smart
A single USB-C/Thunderbolt dock can replace a pile of chargers and dongles. Mount it under the desk or behind the monitor so one cable snaps into your laptop—and your desk instantly looks cleaner.
Label Once, Smile Forever
Put tiny labels on each cable near the device end: “Monitor 1,” “Dock,” “Lamp.” Next time you swap gear, you won’t unravel the whole system.
Safety Matters (and Looks Better)
- Keep power supplies ventilated—don’t bury “bricks” in dense foam or fabric sleeves.
- Don’t overload one strip; use a surge protector with proper ratings.
- Leave a little service loop so connectors aren’t under constant tension.
Cut Even More Cables with Wireless Power
Once the big cleanup is done, trim the last visible cords. ChargeFog’s 48-V wireless ecosystem—Halo Transmitters plus Hybrid Pads—keeps laptops and accessories topped up without a tangle of chargers. Fewer chargers = fewer cables to route.
Your 15-Minute Setup Checklist
- Mount surge strip under desk (rear side).
- Install a cable tray and drop in the strip + dock.
- Run one mains cable to the outlet via a wall raceway.
- Clip and velcro route laptop/monitor/dock leads.
- Swap to wireless keyboard/mouse; shorten remaining cables.
- Label device ends; leave small service loops.
From Tidy to Truly Cable-Light
Great cable management makes your desk calmer, safer, and easier to clean. Add ChargeFog wireless power and you’ll remove the last chargers cluttering your surface—so your workspace looks as focused as you are.